Hi,
I have installed TeeChart Pro but couldn't access it through RadStudio. Could you please point me to a KB where I could find information on how to have this component appear within RadStudio?
Cheers, Dan
TeeChart Pro v2012/17 and Tokyo 10.2
-
Dan Mercado
- Newbie
- Posts: 1
- Joined: Mon Aug 28, 2017 12:00 am
Re: TeeChart Pro v2012/17 and Tokyo 10.2
Hello,
Did you find any error message during TeeChart install? Do you find any error message during the IDE start?
One of the most frequent errors is of the form "Cannot load package Tee9XX. It contains unit *, which is also contained in package Tee9XX0". Find here an explanation on how to fix it.
If you only can't find the components in the Toolbox, then please check the list of Installed components (at "Component\Install Packages...") contains the TeeChart components.
See the HowTo setup Paths in the IDE post for further instructions on this.
Did you find any error message during TeeChart install? Do you find any error message during the IDE start?
One of the most frequent errors is of the form "Cannot load package Tee9XX. It contains unit *, which is also contained in package Tee9XX0". Find here an explanation on how to fix it.
If you only can't find the components in the Toolbox, then please check the list of Installed components (at "Component\Install Packages...") contains the TeeChart components.
See the HowTo setup Paths in the IDE post for further instructions on this.
Best Regards,
 | Yeray Alonso Development & Support Steema Software Av. Montilivi 33, 17003 Girona, Catalonia (SP) |
      |
Please read our Bug Fixing Policy |