I'm trying to run Tee8New.exe and when opening it I get the following message:
"The procedure entry point Chart@UnRegisterTeeTools$qqrpxp17System@TMetaClassxi could not be located in dynamic link library Tee810.bpl
I recently upgraded to v8.04.11395. Did I miss a step when I upgraded?
Thank in advance
Tee8New.exe error
Hi dpatch,
The installer should update your IDE's search paths and library paths but if the installer didn't prompt any error message, the most probably is that in your IDE there still remain references to the old packages. So, could you check that the new references are in the top of your IDE's search paths and library paths?
The installer should update your IDE's search paths and library paths but if the installer didn't prompt any error message, the most probably is that in your IDE there still remain references to the old packages. So, could you check that the new references are in the top of your IDE's search paths and library paths?
Best Regards,
 | Yeray Alonso Development & Support Steema Software Av. Montilivi 33, 17003 Girona, Catalonia (SP) |
      |
Please read our Bug Fixing Policy |