Placing shapes between custom axes

[fabnav]

Hi,

I have a left axis, and some custom vertical axes. I use Start and End position to place them one above the other vertically. I have adjusted the Start and End positions to leave some space between the axes.

I would like to create some rectangular filled shapes to cover up the spaces between the axes. This is to make it easier to distinguish where one starts and the next ends.

I was thinking that I could create some TChartShape series. I need help figurring out how to position them over the spaces between the axes.

Regards,

Bill

[Yeray]

Hi Bill,

In this post I show you a complete example using TRectangleTool.