Steema Central

I shall try to be clear..

I have 3 lines, if I set all to solid, I can change the line width for each idependent of the others, but if I change styles to non-solid lines, funny things happen that reflect line width being held captive.

Example:
Line1 dash
Line1 width 3

Line2 dashdot
Line2 width 1

Line3 dot
Line3 width 1

This results in Lines 2 and 3 displaying at a width of 3 per Line 1, regardlesss instruction otherwise.

Example2:
Line1 solid
Line1 width 3

Line2 dashed
Line2 width 3

Line3 dot
Line3 width 1

This results in Line 3 displaying at a width of 3 per Line 2

Example3:
Line1 dot
Line1 width 3

Line2 dashed
Line2 width 1

Line3 solid
Line3 width 2

This results in Line 2 displaying at a width of 3 per Line 1

Example4:
Line1 dot
Line1 width 1

Line2 dashed
Line2 width 1

Line3 dashdot
Line3 width 3

This results in Line 1, Line 2, and Line 3 displaying as specified.

Example5:
Line1 dot
Line1 width 1

Line2 solid
Line2 width 3

Line3 dash
Line3 width 1

This results in Line 3 displaying at a width of 3 per Line 2 even though Line 2 is set as solid.

And etc., etc.

The line width is being carried over, and I have echoed my variables out right before and after the line code and they are correct. This only occurs for a line set as non-solid that occurs in code after another line. The width instructed is ignored and the lower-in-code Line carries the greater width set by another higher in the code.

Hi,

You are right. I've added it to the wish list to be revised for next releases (TF90016564).
Thanks for reporting it.

It is much needed soon for line discrimination with monochrome printing.

Thanx..

Hi,

I've assigned a high priority to this ticket.