Zooming in histograms
Posted: Wed Feb 27, 2008 2:06 pm
Hi, I just discovered some strange behavior when zooming into Histogram series. If you try zooming into the left side of the Histogram-demo in the TCDemo, you will notice that the first bar of the Histogram never changes width, compared to the other bars.
This report is basically just FYI. However; I also have reported previously (but without being able to create a run-as-is program demonstrating it) about when zooming into Scatter plots, sometimes all the Points in the new view disappear. Typically when zooming into relatively small areas (though larger than the actuator-size ofc). Perhaps there could be some relation between the zooming-issues? That is, unless the disappearing points are on my behalf somehow...
This report is basically just FYI. However; I also have reported previously (but without being able to create a run-as-is program demonstrating it) about when zooming into Scatter plots, sometimes all the Points in the new view disappear. Typically when zooming into relatively small areas (though larger than the actuator-size ofc). Perhaps there could be some relation between the zooming-issues? That is, unless the disappearing points are on my behalf somehow...